LANC Camera Wireless Remote Control Set (Start/Stop)

The Lanparte LP-LANC-02 radio remote control set allows remote triggering of LANC-compatible cameras/equipment (start and stop function) with 2.5 mm LANC connector (e.g. some cameras from Sony, Panasonic, Blackmagic, Canon or LANC-equipment). The set consists of a transmitter and a receiver, the latter can also be used alone as a wired remote trigger. The radio range is up to 30m in an open environment. There are 1/4" threads on the back of both parts.

With optional LP-LANC-02RX receivers, multiple cameras can be triggered simultaneously in a one-to-many camera configuration.

Pairing procedure:
Switch off the camera. Connect the camera cable to the camera (or device with LANC). Connect the receiver to the other end of the camera cable and press the red button on the receiver while simultaneously switching on the camera until the indicator on the receiver flashes. Then release the button on the receiver.

Then press and hold the button on the transmitter. The indicators on the transmitter and receiver flash and then go out. This indicates that pairing is complete. Only then release the button on the transmitter.

A transmitter can be paired with several receivers in the same way.

LANC: Local Application Control Bus System. Two-wire, serial, bidirectional interface with 2.5mm jack plug.